diff --git a/src/libslic3r/PrintObject.cpp b/src/libslic3r/PrintObject.cpp
index 6212a2f76..a7266aedc 100644
--- a/src/libslic3r/PrintObject.cpp
+++ b/src/libslic3r/PrintObject.cpp
@@ -834,7 +834,7 @@ bool PrintObject::invalidate_state_by_config_options(
             || opt_key == "ensure_vertical_shell_thickness"
             || opt_key == "bridge_angle"
             //BBS
-            || opt_key == "internal_bridge_support_thickness") {
+        ) {
             steps.emplace_back(posPrepareInfill);
         } else if (
                opt_key == "top_surface_pattern"
diff --git a/src/slic3r/GUI/Tab.cpp b/src/slic3r/GUI/Tab.cpp
index a88d70fb6..c45ba4e8a 100644
--- a/src/slic3r/GUI/Tab.cpp
+++ b/src/slic3r/GUI/Tab.cpp
@@ -2020,7 +2020,7 @@ void TabPrint::build()
         optgroup->append_single_option_line("infill_combination","parameter/strength-advance-settings");
         optgroup->append_single_option_line("detect_narrow_internal_solid_infill","parameter/strength-advance-settings");
         optgroup->append_single_option_line("ensure_vertical_shell_thickness","parameter/strength-advance-settings");
-        optgroup->append_single_option_line("internal_bridge_support_thickness","parameter/strength-advance-settings");
+        //optgroup->append_single_option_line("internal_bridge_support_thickness","parameter/strength-advance-settings");
 
     page = add_options_page(L("Speed"), "empty");
         optgroup = page->new_optgroup(L("Initial layer speed"), L"param_speed_first", 15);